PLMS Screw nut

Reliability in terms of safety.

This accessory is often used for pewag winner lifting points with special and maximum lengths.

For sizes M8 up to M48 this accessory is available as a set: The nut is manufactured according to DIN 980 V in strength category 10. A washer completes the set. 

From size M56, the nut is 1.5 times as high and manufactured according to DIN 6331. An additional washer is not required here.

Note:

Nuts according to DIN 980V are self-locking nuts, i.e., with a clamping part. This clamping part is responsible for securing the nut (against loosening the nut). They are used when the screw length is only slightly longer than the load thickness (e.g. calculated according to pewag specifications).
If the bolt is much longer than the load (e.g. use the nut for different load thicknesses and bolt protrusions) then it can be tedious to always install and loosen these nuts with a tool. In this case, the use of a nut according to DIN 6331 is preferable. However, you should always check the correct, tight fit of the nut before each lifting operation.


-
Stock: Please specify product option(s).

Consulta de produto


Tabela de especificações

PLMS Screw nut Código thread
[mm]
Thread pitch P
[mm]
SW
[mm]
K
[mm]
S
[mm]
VPE
[piece]
Measurement Image PLMS 8 M8 1,25 13 8 1,60 10
PLMS 10 M10 1,50 17 10 2 10
PLMS 12 M12 1,75 19 12 2,50 10
PLMS 14 M14 2 22 14 3 10
PLMS 16 M16 2 24 16 3 10
PLMS 18 M18 2,50 27 18 4 10
PLMS 20 M20 2,50 30 20 4 10
PLMS 24 M24 3 36 24 4 10
PLMS 30 M30 3,50 46 30 5 4
PLMS 36 M36 4 55 36 6 1
PLMS 42 M42 4,50 65 42 7 1
PLMS 48 M48 5 75 48 8 1
PLMS 56 M56 5,50 85 84 - 1
PLMS 64 M64 6 95 96 - 1
PLMS 72 1)  M72 6 105 108 - 1
PLMS 80 M80 6 115 120 - 1
PLMS 90 M90 6 130 135 - 1
PLMS 100 M100 6 145 150 - 1
- - - - - - -
 1)  Nut acc. to DIN 6331 - no washer